Eaton M112 Data / spares / parts??

Eliot · Post by **Eliot** » Thu May 31, 2007 2:44 pm

You could use an M90 on a 3.5 (again using your figures - i will try to check them for you)

But I would use the 112, as it gives more scope for upping the capacity.

The Original Tom · Post by **The Original Tom** » Thu May 31, 2007 5:33 pm

The M90 does look better for low boost, but if I increased it even a bit it would become less efficient, and we all know that once I start fidling with boost, the only way is up!
Unfortunately though, the contact I had that was trying to shift his M112 cheaply has had a change of heart, so it's going to be a long time before I'm able to afford to do this now... Sorry for the wasted time but it's quite a good tech article any way!

Tom.