Went to 3 motor factors today to get a flexi hose to connect to my sd1 slave cylinder-no luck. It has a 12mm 1.0 pitch thead which seemed to be the stumbling block. Any suggestions?
Ian
Clutch hose!!
Moderator: phpBB2 - Administrators
You could try Pirtek or Think automotive as they will make to order?
Perry Stephenson
MGB GT + Rover V8
9.62 @ 137.37mph
Now looking for 8 seconds with a SBC engine
http://www.youtube.com/watch?v=nVscbPHgue0&list=UUqIlXfSAoiZ--GyG4tfRrjw
https://www.youtube.com/watch?v=eg3avnsNKrc&index=2&list=FLqIlXfSAoiZ--GyG4tfRrjw
MGB GT + Rover V8
9.62 @ 137.37mph
Now looking for 8 seconds with a SBC engine
http://www.youtube.com/watch?v=nVscbPHgue0&list=UUqIlXfSAoiZ--GyG4tfRrjw
https://www.youtube.com/watch?v=eg3avnsNKrc&index=2&list=FLqIlXfSAoiZ--GyG4tfRrjw
-
mike-b
- Forum Contributor
- Posts: 209
- Joined: Thu Mar 25, 2010 8:49 pm
- Location: Markfield, Leicestershire.
Try Earls at silverstone circuit, they made my master to slave on my granny to order.
jThey just need fitting reqd and length.
My hose was stainless braided and plastic coated - 36 inch long £25 - job done.
www.earls.co.uk
jThey just need fitting reqd and length.
My hose was stainless braided and plastic coated - 36 inch long £25 - job done.
www.earls.co.uk
Mike B Drives a 1984 Mk2 Granada ghia V8.
