Lockheed Clutch Slave Cylinder?

jomeo · Post by **jomeo** » Thu May 17, 2012 2:39 pm

Afternoon all.

As the title suggests, we are after a new clutch slave cylinder for our Marcos 3.9.
Now the numbers that we have are either LB13dc002a, or 99364 q396 (taken from the body of the casting).

Now apparently the people to go to would be PowertrackBrakes.co.uk but I'm getting nothing on their phone number and nothing back on emails.

I dont suppose anyone out there would know of another place to get either a replacement unit or a service kit??

Many Thanks as always

joe

SuperV8 · Post by **SuperV8** » Fri May 18, 2012 11:15 am

I can't recognise those numbers, probabbly just casting numbers.

If you can do some measuring I should be able to help find a part number

bore dia
overall length
thread size
width of mounting holes centres
Also a photo would help

Tom.

ged · Post by **ged** » Fri May 18, 2012 8:44 pm

It's probably the same as SD1.

Regards Ged

trev h · Post by **trev h** » Sat May 19, 2012 8:25 am

Just had look at a spare iv'e got & it's got the number 99364cd8d on the side so presume it's same as you've got, it's got a bore of approx 25mm, length of 114mm, & 64mm between centres of bolt holes, & as ged said it's the same as sd1 or at least thats what i replaced mine with, if the pushrods are different lengths just swap them over, plenty for sale on ebay most under £10, in fact the repair kits are dearer than a complete cylinder.

jomeo · Post by **jomeo** » Sat May 19, 2012 10:43 am

Ah nice one, cheers for the heads up on the SD1 shout guys.
Ordered one off the bay.

Thanks again

SuperV8 · Post by **SuperV8** » Mon May 21, 2012 11:21 am

Had a quick look and there are at least 4 similar slave cylinders with slightly different bore / thread sizes! All fitting BL/triumph/Landrover/Rover.
22.2mm bore 7/16unf
22.2mm bore M12x1
25.4mm bore 7/16unf
25.4mm bore M12x1
All same length and mounting hole spacing.
The SD1 actually is listed as a 22.2mm bore with M12x1 thread size.

Tom.