Oil pressure Transmitter on Intermediate Serpentine cover

Slatter · Post by **Slatter** » Mon Jan 29, 2007 6:15 pm

Right another question !

On my old racer the Oil pressure Transmitter was on a pipe between the remote oil fiter housing and the front cover, When i sold the racer that went with it, but i kept the engine.

Where do you normally put a Oil pressure Transmitter On a serpetined front cover, I cant see anywhere that it can go !

Thanks Slatter

Slatter · Post by **Slatter** » Mon Jan 29, 2007 6:38 pm

Forgot to say, i did have a mehanical one, not an electrial one.

Post by **demo2** » Tue Jan 30, 2007 12:52 am

I'll have a look on mine 2nite, there are 3 take off points from memory. I even drilled and tapped a take off 4 oil temp sender.

Slatter · Post by **Slatter** » Tue Jan 30, 2007 6:44 pm

Thanks mate, if you could get a pic it would be even better !

adamnreeves · Post by **adamnreeves** » Sun Feb 11, 2007 7:33 pm

Full and intermediate serpentine covers have the oil pressure sender on the drivers side of the cover.

Please note that the senders are different though even installed in the same place.

This is a photo of my interim timing cover. Note I have installed blanking caps where the oil cooler is usually plumbed in. I am planning on installing an oil temperature sensor in one of them.

Here's a photo of a later serpentine cover as installed on my engine before I found out that it would not work with my application.