Plenum shaft lock tabs

Post by **Coops** » Fri May 18, 2007 11:23 pm

im after these:

they go on the plenum shafts and lock into the linkage and also the securing nut to stop every thing moving and coming loose,
mine are near close to breaking now.

i think standard plenum shaft ones are the same,
not sure about any su or webbers carbs though,

Post by **demo2** » Sat May 19, 2007 1:04 am

I wuda fort any land rover dealer wud ave em,be a ripp off price tho i guess

kiwicar · Post by **kiwicar** » Sat May 19, 2007 5:44 am

are they brass? if so heat them to cherry and quench, this should aneel them and stop them cracking apart.
could get some brass from your local hobby supplyers and make some new ones?
Mike

Post by **Coops** » Sat May 19, 2007 9:19 am

they seem to be made from steel.

i dont mind using second hand ones as long as they are better than mine,

seight · Post by **seight** » Sun May 20, 2007 12:35 pm

I think this is what you want:

"C43231L TAB WASHER FOR STOP LEVER V8 EFI "
30p from John Craddock

http://www.johncraddockltd.co.uk/produc ... no=C43231L

Bought stuff from their website before - good service.

Mike

Post by **Coops** » Sun Jun 03, 2007 11:11 pm

i contacted them, and asked if they could do the postage cheaper,
as the parts came to £1.20 and they wanted £7.50 postage

had no reply so went and bought 8 from local landrover dealer, so i have spares if any one needs to buy any,

i have also ordered 8 throttle shaft seals, price not known yet.

Post by **Coops** » Mon Aug 20, 2007 3:56 pm

just an update,
have the spindle lock tabs and spindle shaft seals here now,
have enought to do about 5 TP setups