Page 1 of 1
ROVER V8 LT77 GEARBOX CLUTCH SLAVE
Posted: Mon Jan 29, 2007 8:58 pm
by scimitar0
Hi
I am currently fitting a rover V8 to my scimitar SE5A, I have misplaced the bolts for the clutch slave cylinder for the LT77 gearbox, doh ! can anyone tell me what size and thread they are please ?
cheers
Phil
Posted: Wed Feb 07, 2007 9:50 pm
by Andy515666
Hi Phil
I had the same problem and when I used what I thought were the right bolts i ended up threading one of the holes.
After much loud vocal abuse at myself I ended up getting a tap set and re threading both holes to fit different bolts. I wlil have a look tonight and see what the side of the bolts are.
Andrew
Posted: Thu Feb 08, 2007 11:30 am
by jrv8
Hi ,
Thread size is M8
an M8 x 35 bolt should be ok for length.
Regards
Jim
Posted: Thu Feb 08, 2007 7:19 pm
by scoobyv8
jrv8 wrote:Hi ,
Thread size is M8
an M8 x 35 bolt should be ok for length.
Regards
Jim
^^^^^
i'm guessing you mean M8
by 1.25 pitch, by 35 mm long
just thought i'd clarify that, to keep the chap right
George