Page 1 of 1
bellhousings
Posted: Thu Sep 25, 2008 5:25 pm
by Seight-V8
hiya all,
just had a thought and
anyone know if theres a difference between a LT77 bellhousing and a R380 bellhousing.
Also what is the largest clutch each can take.
cheers
scott
Posted: Thu Sep 25, 2008 6:21 pm
by v8alex
The bellhousing is the same for both boxes.
There is a difference between bellhousings for 2WD & 4WD vehicles I believe.
Not sure about the clutch size question.
Alex
Posted: Thu Sep 25, 2008 7:54 pm
by topcatcustom
Gulp- difference between 2wd & 4wd being..... I may have just bought a 4wd one
Posted: Fri Sep 26, 2008 6:53 am
by ChrisJC
The 4WD one is much longer than the 2WD one. The 2WD one is 'nornal' i.e. what you'd expect to see in a car. The 4WD one looks long, there's much more space than is needed to house the flywheel and clutch.
Chris.
Posted: Fri Sep 26, 2008 8:00 am
by katanaman
yes the 4x4 housings wont work on a 2wd box. They bolt on but the input shaft is far too short and you will have horrible alignment problems with the gear stick assuming the bellhousing even fits the car.
Posted: Fri Sep 26, 2008 9:36 am
by topcatcustom
Time to start looking again then
the one I have has scoop shapes round the top half whereas (I think) the 2wd is smooth with 2 ribs
ps: Does anyone know/can anyone measure the length of the 2wd bellhousing face to face? So I can double check mine before I sell it!!!
Posted: Fri Sep 26, 2008 11:40 am
by v8alex
I had exactly the same problem and bought a 4WD bellhousing by mistake. Here's a pic of the two types:
The top pic being the 2WD unit. The dirt plate won't fit the 4WD bellhousing either and the location for the clutch slave cylinder / pushrod are in very different places.
Alex