servo assisted clucth
Posted: Thu Jul 03, 2008 4:59 pm
as title how would this be done
Get a remote servo and just plumb it in.
I know that the Rover P6 used one, I'm sure more vehicles did also.
Chris.
The V8 Owners Forum -
Welcome to the well-known V8 Owners Forum, no matter what you drive if its V8 Powered you'll be made very welcome.
https://v8forum.co.uk/forum/
servo assisted clucth
Page 1 of 1
Posted: Thu Jul 03, 2008 5:38 pm
Posted: Thu Jul 03, 2008 6:55 pm
if this is to put a hand operated clutch on the gear leaver you need to use a car type master cylinder and some linkage, a bike leaver and master cylinde does not have enough stroke and does not move enough fluid. Not uncommon mod on club rally minis for a while (great for late left foot breaking into hairpins
).Mike
Posted: Thu Jul 03, 2008 8:34 pm
no its for a normal clucth which is really dam heavy was toying with the idea of fiting a servo to it 
Posted: Fri Jul 04, 2008 7:08 am
There might be something wrong with the clutch then if it's too heavy?
Chris.
Chris.
Posted: Fri Jul 04, 2008 7:43 am
Change the master cylinder for 1 size smaller diameter
Cost of master is about £25
Cost of booster plumbing etc - probably 8 times higher
But check you will still have enough movement on the slave to fully release the clutch
Also check the hoses / pipes it may hves been pinched.
Dependant on what you plan on doing (Drag starts) - to allow quicker release increase the pipe diameter to allow greater flow through it
Ian
Cost of master is about £25
Cost of booster plumbing etc - probably 8 times higher
But check you will still have enough movement on the slave to fully release the clutch
Also check the hoses / pipes it may hves been pinched.
Dependant on what you plan on doing (Drag starts) - to allow quicker release increase the pipe diameter to allow greater flow through it
Ian