The V8 Owners Forum -

Hello, this may be a silly question but, does it matter which side of a brake master cylinder goes to which end of the car, the master has 2 outlets, was going to put the front to to fronts and rear to to rears. unless anyone knows different. Dont know if there is anything internal i should be aware of. Its on a Triumph TR7.
Thanks.

I would think there may be a possibility of dis similar bore sizes front to back

I believe it's nearest the servo/rod to the front and the forward most to the rear, but please check, as ian said a lot of cars have diffrent size holes, the larger of the 2 being the front brake, also it's not unknown for them to have stepped bores, more fluid at the rear of the cylinder and less at the front, john

I had to check and found this .... i hope this link is ok ? john
http://www.britishv8.org/Articles/Tande ... inders.htm