The V8 Owners Forum -

I’m looking for a particular part and wondered if anyone knows where to find it..

Had a problem with the clutch release so took engine and gearbox out of car, cracked open bellhousing and found that my clutch release arm was hanging off the release bearing.

The reason was that on the end of the arm (the end with the 2 circular prongs) I only have one square nut to guide the arm onto the release bearing with. Looks like I have a missing square nut.

I have looked at getting a new arm but nobody seems to know anything about the square nuts.

The picture shows the arm and at the top of the picture is the 1 square nut I do have.




Anyone??
Thanks in advance

Rimmer bros have them listed,
they call it a slipper pad, http://www.rimmerbros.co.uk/rimmer/rover/sd1/clutch
Ian

You da man

I spoke to rimmer bros this morning and the guy i spoke to knew nothing about them. Ah well - Thank you Ian and for quick response.

Perhaps its time to call Rimmers again, quoting their part number, and asking for discount as you appear to be doing their job for them.

Would be nice - Although discount on 80pence
Last thing i bought was some injector seals upper and lower think it was about £45 though.

Dude I have a spare used throw arm in good nick and slipper pads if you dont wanna pay new prices? Drop me a PM.

Also got a brand new release bearing never even been out of the packet!

Got them yesterday, The release bearing i have is new already.

Thanks for letting me know anyways.

Cheers