Page 1 of 1
Plenum shaft lock tabs
Posted: Fri May 18, 2007 11:23 pm
by Coops
im after these:
they go on the plenum shafts and lock into the linkage and also the securing nut to stop every thing moving and coming loose,
mine are near close to breaking now.
i think standard plenum shaft ones are the same,
not sure about any su or webbers carbs though,
Posted: Sat May 19, 2007 1:04 am
by demo2
I wuda fort any land rover dealer wud ave em,be a ripp off price tho i guess
Posted: Sat May 19, 2007 5:44 am
by kiwicar
are they brass? if so heat them to cherry and quench, this should aneel them and stop them cracking apart.
could get some brass from your local hobby supplyers and make some new ones?
Mike
Posted: Sat May 19, 2007 9:19 am
by Coops
they seem to be made from steel.
i dont mind using second hand ones as long as they are better than mine,
Posted: Sun May 20, 2007 12:35 pm
by seight
I think this is what you want:
"C43231L TAB WASHER FOR STOP LEVER V8 EFI "
30p from John Craddock
http://www.johncraddockltd.co.uk/produc ... no=C43231L
Bought stuff from their website before - good service.
Mike
Posted: Sun Jun 03, 2007 11:11 pm
by Coops
i contacted them, and asked if they could do the postage cheaper,
as the parts came to £1.20 and they wanted £7.50 postage
had no reply so went and bought 8 from local landrover dealer, so i have spares if any one needs to buy any,
i have also ordered 8 throttle shaft seals, price not known yet.
Posted: Mon Aug 20, 2007 3:56 pm
by Coops
just an update,
have the spindle lock tabs and spindle shaft seals here now,
have enought to do about 5 TP setups
