The V8 Owners Forum -

Posted: **Sat Apr 21, 2007 3:41 pm**

Hi can anyone help me out,
I need the use of a hydraulic press to remove two pistons from a rods, press fit pin and I don't have a vice big enough!
I am in Milton keynes and will gladly travel a sensible distance.
many thanks
Mike

Posted: **Sat Apr 21, 2007 4:52 pm**

Dorset too far?

Posted: **Sat Apr 21, 2007 5:09 pm**

thanks Ian
was sort of hoping to be back by lunch tommorow,

however if I have no luck by the end of tommorow with a closer offer I would greatfully take you up on the offer next week end

many thanks
Mike

Posted: **Sat Apr 21, 2007 8:42 pm**

Real Steel in Uxbridge will do it for a few quid. Or try Martin who owns Marlin Motors in Bletchley. He may be able to Help. He is a very useful contact.

Posted: **Sun Apr 22, 2007 5:45 am**

thanks I shall introduce myself and try Marlin motors,
best regards
Mike

Posted: **Sun Apr 22, 2007 7:57 am**

hI,
I'm in Newport pagnell and have a 10 ton press you can use.

pm me for contact

Posted: **Sun Apr 22, 2007 4:09 pm**

thanks Eliot
PM sent
Mike