rover 4.2 v8 rebuild

General Chat About Engine Build

Moderator: phpBB2 - Administrators

Post Reply
kiwicar
Forum Contributor
Forum Contributor
Posts: 5461
Joined: Sat Nov 18, 2006 5:00 pm
Location: Milton Keynes

Post by kiwicar »

:whs
when doing a rebuild you need to get the oil gallerys clean, otherwise there is little point in putting new parts in just to have them wear as a result of poor oil supply/ contaminated oil. You can do a rebuild with the block in the car, but for 10 minutes work to get the block out you save alot of time and grief on the rebuild.
Best regards
Mike


poppet valves rule!
Top
POAH
Helpful or Confused
Helpful or Confused
Posts: 97
Joined: Tue Jan 13, 2009 2:52 pm

Post by POAH »

so what ever I do its an engine out job. somthing to get done when I get the bulkhead replaced then
Top
Post Reply

Return to “Engines Area”