Hot wire AFM

General Chat About Electrics, And Ignition Systems.

Moderator: phpBB2 - Administrators

Post Reply
countrymansouth
Newbie
Newbie
Posts: 4
Joined: Thu Jul 12, 2012 8:24 pm
Location: Horsham west sussex

Hot wire AFM

Post by countrymansouth »

Gents I have a 3.9efi RRC running an entirely standard non cat hot wire system. Can anyone tell if there is a special procedure for resetting the relationship between the AFM and the ECU after I have run the engine with the AFM disconected.


kiwicar
Forum Contributor
Forum Contributor
Posts: 5461
Joined: Sat Nov 18, 2006 5:00 pm
Location: Milton Keynes

Post by kiwicar »

Hi
I don't think there is one as it is not intended to be run like that, however to get it out of limp home mode. . . which I think it will be in. . . disconnect the battery for at least 1 minute then reconnect the battery, obviously first checking everything that should be attached is attached! :?
Best regards
Mike
poppet valves rule!
countrymansouth
Newbie
Newbie
Posts: 4
Joined: Thu Jul 12, 2012 8:24 pm
Location: Horsham west sussex

Post by countrymansouth »

Have done as advised, many thanks. Nick
countrymansouth
Newbie
Newbie
Posts: 4
Joined: Thu Jul 12, 2012 8:24 pm
Location: Horsham west sussex

Post by countrymansouth »

since resetting the ECU egine starts virtually instantly whereas before took a few churns to go, also hot restart much better again virtually instant. I can only guess it has been running on limp home mode luckily it only starts on petrol and then switches to LPG. Thanks for the advise.
User avatar
jimbob
Helpful or Confused
Helpful or Confused
Posts: 122
Joined: Tue Feb 10, 2009 8:00 pm

Post by jimbob »

Funny you should say that, i just logged into mine, been running way too rich, looks like i'm back to happy days again.

How do you know its in limp mode i had no errors or dash lights up.

The only other change I've made is by coming off super plus petrol, cant see that making a huge difference.
User avatar
Ian Anderson
Forum Contributor
Forum Contributor
Posts: 2459
Joined: Sun Nov 19, 2006 9:46 pm
Location: Edinburgh

Post by Ian Anderson »

jimbob wrote:Funny you should say that, i just logged into mine, been running way too rich, looks like i'm back to happy days again.

How do you know its in limp mode i had no errors or dash lights up.

The only other change I've made is by coming off super plus petrol, cant see that making a huge difference.
Easiest way is fuel consumption - it will drink the stuff!
Or with engine running go around to tail of car if on limp home mode the fumes will make your eyes water! Really they stink!

That is my method but then my Hotwire system is in a "kit car"

Ian
Owner of an "On the Road" GT40 Replica by DAX powered by 3.9Hotwre Efi, worked over by DJ Motors. EFi Working but still does some kangaroo at low revs (Damn the speed limits) In to paint shop 18/03/08.
User avatar
jimbob
Helpful or Confused
Helpful or Confused
Posts: 122
Joined: Tue Feb 10, 2009 8:00 pm

Post by jimbob »

Hi,

Cheers for the reply, I know it’s a petrolholic, I did that the exhaust is a little sooty, no cats it’s a tune resistor. The smell wasn’t bad not eye watering, before was about 15mpg now back up at 18-20 mpg.

Jim
Post Reply

Return to “Electrical & Ignition Area”