The V8 Owners Forum -

I will second Pentland they got me some odd parts very quickly.

photo bucket gives you different options to copy and paste into message boards use the option for clickable thumbnails it keeps the picture nice a small on the board.

Get a range rover haynes manual as this has a good section on checking the sensors and all output voltages and inputs. You need two relays which are N/O with twin outputs (they also have a small block diode fitted to stop back feed) and you should be able to check the wiring diagram to see which two...

I have fitted an LT77 to the back of a 3.9 and when I tried to move the clutch release arm through the bellhousing[using the shank of a hammer] it feels solid.Should I be able to move the lever by hand?I want to make sure the clutch is correct before fitting it in the car. Not tried without the sla...

Thanks folks thats that then

Cheers George

Does anyone know if the SD1 slave cylinder is the same as the Land Rover slave as the LR slaves are a lot cheaper to buy as mine is now leaking

George

Looking at the wiring diagram posted you need to see if you have a feed on pin 20 on ecu this should be live for 2 secs when ignition turned on then drops of. if this happens the fuel relay may be stuck closed causing a feed all the time pull the relay and see if pump cuts out , if still running a s...

Might be stupid but is the pump in the right way and not trying to pump to tank

George

http://www.corvetteactioncenter.com/spe ... s1ls6.html

Total Dressed Engine Weight
Auto. - 457.6 lbs. (208 kg);
Manual - 497.2 lbs (226 kg)

Found this hope it helps

George

Can anyone help regarding throttle pots. I am using the hotwire setup but with home made plenum fitted with a BMW throttle body, when I connect the BMW throttle pot up to the hotwire the voltage does not move up and down with the pedal. If I disconnect the signal wire from the hotwire (BMW throttle ...

katanaman wrote:
Sorry for the rant and I don't even have a 4x4 but I am sooooo fed up of the motorist getting shafted. As I live in Scotland I can't even go to the pub and have a beer and a smoke to get over it cos they banned that too!!

Just have to start smoking some tyres

Check out the end of this post on locostbuilders forum

http://www.locostbuilders.co.uk/viewthr ... ?tid=61264

He is selling a plenum with an end entry

Cheers George

From my prevous post below i have now worked out what i think each unknown wire i have actually does, but i would be greatfull if i could have second opinions before i wire them up ! Its on a 3.9 hotwire system but has had a new complete engine loom made. i used these http://www.mediafire.com/?byzn...

http://www.mediafire.com/?byznzniibq0

This is a list of the pin outs on the ecu in PDF format

George

I saw a while ago oval section exhaust tubing in a hot rod mag does anyone know of a supplier in the UK as this may solve my clearance issue?

Cheers George